Products

U-Bolt to fit Truck Arm Late Models  9.5" from the bottom of the radius to the end of the threads 4.2" Wide center to center 3/4-16 thread

2 pack

Lower Control Arm Front Slug (Engraved for identification) Please note: Quantity of one equals one slug (not a pair).

Upper Control Arm / A-Plate Slug (Engraved for Identification) Please note: Quantity of one equals one slug (not a pair).

Helps move air away from interior of car, to eliminate drag, create side-force, and funnel air to the driver.  11" long.

Over engine bar mount: 1" diameter x 1.575" long, made from carbon steel and designed to fit our bay bar insert:  Bay Bar Threaded Insert — RRC Qua...

90 deg countersink with 3/8"-24 threads, 2" overall length; made from carbon steel. Quantity discounts available: 3–10 = 5% off 11–24 = 10% off 25...

1.125" Jack Bolt Style 

Billet Aluminum String Bars make aligning your Late Model Chassis easy. Front and Rear String Bars are machined in house to thread into your RRC an...

The RRC Billet Idler Arm is designed to eliminate center link deflection resulting in stable bump-steer under extreme conditions. RRC utilize a dou...

Made out of aluminum, 2.5" long with 1/4"-20 female thread on one end, flange is 1.25" diameter.

Made out of aluminum, 2.5" long with 3/8-16 female thread on one end, flange is 1" diameter.

Made from ABS material and designed to be mounted to a 3" hole and used with 3" diameter hose.

Laser Cut Camber Shim Kit  .090 1/8 3/16   Some Deburring Required 🪒

Our RRC Center Link is engineered to create as close to a linear bump curve as possible. This allows the crew chief to implement any strategy witho...

Centerlink / Steering Foot Slug (Tapered Hole) Multiple Sizes Available Please note: Quantity of one equals one slug (not a pair).

Made from carbon steel and designed for a 5/8" countersink bolt; sleeve is 1-3/8" diameter x 1-1/8" long. Quantity discounts available: 3–10 = 5% ...

Made from carbon steel and designed to be used with Timken LL52510 tapered roller bearing cups with a 1.6563" diameter and RRC bearing seals with a...

Chassis Casters fit inside a 3x4" .120" wall frame rail and raise the chassis to approximately 16” off of the ground. We laser cut and build these ...

Two Tig welded 1” .095 chromoly seat rails with 1/2” countersunk bushings

Clamp on track bar mount for rear end

Straight and 90 Made for HEI style contacts Available in 16 and 18 inch lengths

Coilover upper control arm suitable for 1:1 shock/bumpstop setup. Custom sizes and offsets are also available. Please contact us at 704-512-0262 or...

Steel housing made for COM12 monoball bearings. Housing is 1.735" OD x 2" long, bearing is centered within housing. Quantity discounts available: ...